Seat Runners

I fitted the runners to the seats.  The mounting surface was uneven due to the leather folds of the seat so I spaced off at the mouting bolts using penny washers.  This then allowed the runner to be perfectly straight with no chance of being stiff due to distortion.

I also decided that it would be neater and easier to get the bolts out in future if they went up through the body.  Here in Shetland any exposed bolt thread will corrode very quickly meaning that it is much harder to get bolts undone.

I made threaded insert blocks which fit inside the runner where the bolt from underneath will screw into.  The block has a small retainer screw to hold it into place.  This was done for all 8 fixing places.

Door Switches

Before fitting any carpets, I decided to fit door switches in case I wanted footwell lights.  The GD loom has wires for it.

I decided to use microswitcehs so I had to make a small stainless bracket to be able to fit them to the door hinge mount.  The mount was drilled and tapped and the switch mounted.

To trigger the switch, the simlest solution I could come up with was to drill and tap into the hinge itself and screw in a button head set screw.  This is slightly rounded and easily presses on the switch to trigger it.

The wire was run from the dash and a small cable clip was screwed to the pillar to keep it out of harms way.

I also fitted the same type of switch to the handbrake for the brake test circuit.  This was bolted directly to the handbrake bracket - I don't seem to have any photos..

Door Open

Door Closed

Headrests

The headrests and stainless brackets were supplied by GD.  I screwed the headrest onto the bracket and placed the headrest so that it was in the centre of the hoop's radius.  I then marked where to drill the holes and tapped the hole out to M5.

I wasnt too happy with the weld finish where the threaded boss is for the headrest, so I added some weld using the MIG, and then filed, polished back the bracket so it was smooth.

The headrests were then bolted in position using threadlock.