The flywheel was also fitted. I cleaned off the stickers and using ARP bolts fitted them with threadlock and some of their own lube. These were torqued up to 84 ft lbs as per the instructions.
GD427 MK IV
What my car should look like when finished - Stoneleigh 2015
Friday, 5 February 2016
Engine Spigot Bearing & Flywheel
I fitted the spigot bearing that holds the input shaft to the gearbox in the crankshaft. This was tapped into position using a 19mm deep socket and a plastic mallet. It went in pretty easy. I was told to put the bearing in so the roller bearings were away from me. The photos should show this.
The flywheel was also fitted. I cleaned off the stickers and using ARP bolts fitted them with threadlock and some of their own lube. These were torqued up to 84 ft lbs as per the instructions.
The flywheel was also fitted. I cleaned off the stickers and using ARP bolts fitted them with threadlock and some of their own lube. These were torqued up to 84 ft lbs as per the instructions.
Subscribe to:
Post Comments (Atom)
No comments:
Post a Comment