Carpets

I thought I had better set all the carpets in to try and figure out what piece goes where.  There are a lot of different pieces!

Everybody else seems to start with the tunnel - so I thought I would start with that.  It was too long to fit in my cockpit, so the first step was to cut it to length.  I had to figure out where the taper fitted the tunnel best, then I could get a measurement to the rear to be able to cut it.  Once this was done the front and sides could be cut to length.  I then cut out the hole for the gearlever.

I laid in the side carpets and also rear caprpet to see how it was all going to line up with each other and also the fibreglass bodywork at the hinges and door closer.  Not going to be easy!  

Some of the piping appeared to be different to other builders, and the rear panel appeared slightly big.  I do have the sound deadening installed, but that shouldn't make it too different.  A bit more head scratching required.